Water-Stop Device; Water Drainage - AEG Electrolux LAVAMAT 72850 User Manual

Do not place the inlet hose downwards. Angle the hose to the left or
right depending on the position of your water tap.
3. Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten the ring nut again to prevent
leaks.
4. Connect the hose to a tap with a 3/4" thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is too short and you do not wish to
move the tap, you will have to purchase a new, longer hose specially designed
for this type of use.

Water-stop device

The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in
the hose which could develop due to natural ageing of
the hose. This fault is shown by a red sector in the
window "A". Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.

Water drainage

The end of the drain hose can be positioned in three
ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be above the trap so that the bend
is at least 60 cm above the ground.
Directly into a drain pipe at a height of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must always be ventilated, i.e. the inside diameter of
the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
Installation 47