Connecting An Antenna; Am Loop Antenna; Fm Indoor Antenna - Denon DNP-720AE Owner's Manual

Connecting an antenna

• Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
(vpage 13 "Listening to FM/AM broadcasts"), fix the antenna
with tape in a position where the noise level becomes minimal.
• When listening to radio stations, always make analog connections
(vpage 4 "Analog connections").
Direction of broadcasting station
FM outdoor
antenna
75 Ω coaxial
cable

FM indoor antenna

(Supplied)
Black White
q
AM outdoor
Ground
antenna
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
2
Insert the projecting part
into the square hole in the
stand.

AM loop antenna

(Supplied)
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without
assembling.
Standing alone
Use the procedure shown above to
assemble.
w e
NOTE
• Do not connect two FM antennas simultaneously.
Stand
• Even if an external AM antenna is used, do not disconnect the AM
Square
loop antenna.
hole
• Make sure the AM loop antenna lead terminals do not touch metal
Loop parts of the panel.
Projecting
antenna
• If the signal has noise interference, connect the ground terminal
part
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
Nail, tack, etc.
ENGliSh
5