Rear Panel Controls & Description - Ahuja SWX-200P Operation Manual

1. POWER Switch
2. POWER LED
This LED glows when the power is switched ON.
3. CLIP LED
This LED glows when the output is at clipping
level.
4. RESET Button
This button pops out when the circuit protector
trips. The circuit protector prevents the powered
subwoofer from getting damaged on account of
short circuits, DC offset and Overdrive conditions.
Rectify the cause and press the RESET button
for resetting normal operation of the subwoofer.
5. FAULT LED
This LED glows in either case when the output is
shorted, in case of DC offset or overdrive
conditions.
6. RESET Button
7. FAULT LED
• Rear Panel Controls & Description
6
5
4
3
2
11
12
1
8. VOLUME Control
For adjusting the output level of the subwoofer.
9. Crossover Frequency Selector Switch
This switch selects the high frequency at which
the signal to the subwoofer is cut off. 80Hz or
120Hz can be selected.
10. Preamplifier Input Jack Socket
For accepting an unbalanced signal from a
cassette player/ recorder or the preamp out of an
audio amplifier. Sensitivity is 200mV.
11. Line Input Jack socket
For accepting an unbalanced signal from an
audio mixing console or the line out of an audio
amplifier. Sensitivity is 1V.
12. AC Inlet socket with built in fuse (Rating 10
AMP 250V)
Connect the provided AC Mains cable in this socket
for AC mains operation. The fuse protects the
amplifier from any excessive current flow. An
additional 3A fuse is also provided as an accessory.
5
7
8
9
10
SWX-200P