Table of Contents
Advertisement
Cooling Your Room
20
E-
You must select the COOL mode if you wish to adjust the :
N Cooling temperature
N Fan speed when cooling
1
If necessary, press
N The On/Off indicator on the receiver & display unit comes on.
Result:
N The air conditioner runs in the mode selected when the
unit was last used.
N The receiver & display unit beeps.
IMPORTANT
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
N Plugged in
N Stopped
lt will start up normally after three minutes.
2
To select the COOL mode, press the Mode button until
at the top of the wireless remote controller.
N The receiver & display unit beeps.
Result:
N The air conditioner runs in COOL mode.
N N
o o
t t
e e
You can change modes at any time.
N N
o o
t t
e e
3
To adjust the temperature, press the Temperature buttons one or more
times until the required temperature is displayed. Possible temperatures
O
are between 18
C and 30
N Each time you press Temperature buttons:
Result:
- The temperature is adjusted by 1
- The receiver & display unit beeps.
N The air conditioner starts cooling, provided that the room
N
temperature is higher than the selected temperature ; the fan
N
will, however, operate.
4
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
Automatic(rotated :
Low
Medium
High
(ON/OFF) button.
O
C inclusive.
O
C.
➔
➔
is displayed
)
Advertisement
Table of Contents
