Kawai Concert Performer CP136 Owner's Manual page 39

Basic Controls
No Retrigger When the note played by the Solo part is released, The Solo part will not
automatically play the next available priority note.
The Solo part will only play a new note based upon the Solo priority setting. For example, when
the Solo priority is set to Top Note, and you release the highest note, the Solo part will only play a
note when you press a key that is higher than the currently held notes.
To set the Solo Priority and Trigger Mode:
1) Press and hold the PERFORMANCE button. The Performance screen will be displayed.
2) Press the SOLO PRIORITY button (R1) or the TRIGGER MODE button (R2) and use the
dial to assign a setting.
3) Press the PERFORMANCE button to exit.
SOLO MODE
When using Solo part, you can select between two Solo Modes.
Layer The sound assigned to the SOLO part will be layered on top of the RIGHT 1 and
RIGHT 2 Parts.
Split Only the sound assigned to the SOLO part will be heard when you play above a
specified key (split point) on the keyboard. The default split point is C5 but you can
freely change the split point to any key on the keyboard. When the SOLO Part is
activated in Split mode the split point will be displayed in the LCD screen using the
same 88 note diagram that is used to display the Left/Split split point. The keys
assigned to the Solo part above the specified split point will be shown with a black
bar above them. There is no arrow to indicate the Solo split point because the split
point for the Solo Part cannot be changed on the main screen.
To set the Solo Mode and Solo Split point:
1) Press and hold the PERFORMANCE button. The Performance screen will be displayed.
2) Press the SOLO MODE button (R3) and use the dial to select the mode.
3) If the Solo Mode is set to Split, then press the SOLO SPLIT POINT button (R4) and use
the dial to set the split point.
4) Press the PERFORMANCE button to exit.
31