Brightness; Smart Zoom; Smart Zoom Settings; Enable Overview Mode - Navfly N29050-V1 User Manual

Smart powersave
You can also initiate this special feature of NAVFLY Navigator. Smart Powersave will
light up the screen only when you press or tap a button, or if NAVFLY Navigator has
something to show you. After a few seconds the light level decreases, and after
another few seconds the backlight turns off. This helps you achieve a longer battery
life.
5.6.2.2

Brightness

With this switch you can instruct NAVFLY Navigator to use the original settings of the
PND device (previously set in the operating system at Start/Settings/Backlight), or
you can set the backlight level separately for both daylight and night modes, thus
enhancing the effect of the night Color scheme.

5.6.3 Smart Zoom

Smart zoom is a lot more than just a usual automatic zoom.
While navigating a route: when approaching a turn, it will zoom in and raise the view
angle to let you easily recognize your maneuver at the next junction. If the next turn
is at a distance, it will zoom out and lower the view angle to be flat in order to let you
see the road in front of you, or it can even switch to an Overview mode to let you
follow your position on the map.
While cruising: if there is no active route and you are just driving, Smart Zoom will
zoom in if you drive slowly and zoom out to the limit set here when you drive at high
speed.
These automatic features can be personalised on this screen.
5.6.3.1

Smart Zoom settings

You can set how close Smart Zoom can zoom in when approaching the next turn
(Zoom-in limit), and the maximum zoom level to zoom out when the next turn is
further away (Zoom-out limit). The default values are set to be optimal in most cases.
5.6.3.2

Enable Overview mode

You can configure how the Overview mode is triggered when the next turn is at a
distance.
69