Cursor (No. 7); Map Scale (No. 8); Menu (No. 9); Map Orientation And Overview (No. 10) - Navfly N29050-V1 User Manual

visible. Use Lock to return to North-up or Track-up orientation (the one previously
selected).
When Smart Zoom is enabled, scaling or tilting the map also stops the automatic
zooming or automatic tilting respectively. To reactivate Smart Zoom, tap this button.
Tip: In Advanced settings you can set a delay time after which NAVFLY Navigator
pushes the Lock button for you automatically (5.6.3.3). This can be turned on for re-
enabling both Lock-to-Position and Smart Zoom.

4.5.5 Cursor (No. 7)

As described in 4.4.7, if you tap the map somewhere or select one specific item in
Find, it will become the selected point on the map, marked with a small red dot and
radiating red circles to make it conspicuous. You can use this point as starting point,
via point or destination for your route, you can search for a POI near it, mark it with a
pin, or save it as a POI.
Note: When GPS position is available, the Lock button will appear indicating that you
have disabled Lock-to-Position. Tapping the Lock button will re-enable the position
lock and move the cursor back to the current GPS position. The same happens when
NAVFLY Navigator restores Lock-to-Position automatically, if it is set in Advanced
settings (5.6.3.3).

4.5.6 Map scale (No. 8)

The scale indicator is only available on the Map screen. In 2D map view it represents
the scale of the map. In 3D view it is the scale of the nearest part of the map only.
You can use it in both 2D and 3D modes to scale the map. Drag and pull it right to
zoom in, or left to zoom out.

4.5.7 Menu (No. 9)

This button opens the Menu with the Find engine, the Quick menu, the Route menu
and the exit button that takes you to the Main menu screen. The Menu will be
described in detail later in 4.7.

4.5.8 Map orientation and Overview (No. 10)

You can view the map screens in three different presentation modes. This switch will
cycle through them in the following order.
33