Table of Contents
Advertisement
Turning On and Listening to AM and FM Radio—Continued
When tuned into a station, the
TUNED
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Adjusting the Antennas
Adjusting and installing the FM antenna
Choose a location for the FM antenna while
listening to an FM station.
1
Change the direction of the
antenna to achieve the best
possible reception.
20
indicator appears.
TUNED
2
Affix the antenna with a thumbtack. (Do not
push the thumbtack through the antenna.)
Caution: Be careful not to prick your finger!
Number buttons
Direct Tuning
Tuning into Stations by Frequency
You can tune into AM and FM stations directly by
entering the appropriate frequency.
1
Press the [Direct Tuning] button.
Remote controller
(Actual display depends on country.)
2
Within 8 seconds, use the num-
ber buttons to enter the fre-
Remote controller
quency of the radio station.
For example, to tune into an FM sta-
tion at 87.5 MHz, press [8], [7], and
[5].
Adjusting the AM antenna
Adjust the location and position of the
AM antenna while listening to an AM sta-
tion to achieve the best possible reception.
Advertisement
Table of Contents
