Table of Contents
Advertisement
Connecting the TUN-3.7
Before Making Any Connections
• Refer to the instructions that came with the com-
ponent you are connecting.
• Do not plug in the power cord until all other con-
nections are complete.
• Do not bind audio cables with power cords and
speaker cables. Doing so may adversely affect the
sound quality.
• To prevent interference, keep power cords and
speaker cables as far away as possible from the
antennas.
Connecting to an Amplifier
Use the supplied audio cable to connect the TUN-3.7's
AUDIO OUTPUT L/R jacks to the TUNER IN jacks on
your amplifier, as shown.
To use the
system functions, use the supplied
cable to make an
Supplied audio
cable
L
R
TUNER
Note:
• If the TUN-3.7 is used with another Integra/Onkyo
component, refer to its instruction manual as well.
16
connection (see the next column).
TUN-3.7
Supplied
cable
Amplifier
RCA Audio Connection Color Coding
• Red plugs are used for the right channel, white
plugs are used for the left channel.
Left (white)
Right (red)
• Push each plug in all the way to make a good con-
nection (loose connections can cause noise or mal-
functions).
Right!
Wrong!
About the System Functions
If you connect the TUN-3.7 to another Integra/Onkyo
-capable component with the supplied
and audio cable, you can use the following system func-
tions.
cables are special cables solely for use with
Integra/Onkyo products.
Auto Power On
When you turn on the TUN-3.7, your Integra/Onkyo
amplifier or receiver will turn on automatically. (The
amplifier's POWER switch must be set to ON for this to
work.)
Direct Change
When you select a radio preset or change the band (AM,
FM, etc.), your Integra/Onkyo amplifier will automati-
cally select the TUN-3.7 as the input source.
Remote Control Operation
You can control the TUN-3.7 by using your Inte-
gra/Onkyo amplifier or receiver's remote controller. See
the amplifier or receiver's instruction manual for details.
L
R
cable
Advertisement
Table of Contents
