Connecting The 12V Trigger Jacks - Integra TUN-3.7 Instruction Manual

Connecting the TUN-3.7—Continued
With (Remote Interactive), you can control your
-capable Integra/Onkyo CD player, TUN-3.7, and
so on with your amp's remote controller.
• To use , you must make an analog audio con-
nection between your amplifier and each audio
component.
Integra/Onkyo amplifier, etc.
Integra/Onkyo
CD player, etc.
TUN-3.7
Remote Interactive
Dock, etc.
Notes:
• Push each plug in all the way to make a good connec-
tion.
• Use only dedicated cables for
cables are supplied with Integra/Onkyo tuners
and players (DVD, CD, etc.).
• Some components, including the TUN-3.7, have two
jacks. They're both the same, so use either one.
• jacks should be connected only to Integra/Onkyo
components. Connecting them to another manufac-
turer's component may cause a malfunction.
• Some components may not support all
See the manuals supplied with your other Integra/
Onkyo components for more information.
jack
jack
jack
cable
connections.
functions.

Connecting the 12V Trigger Jacks

To have the TUN-3.7 turn on automatically when
another component is turned on, connect the TUN-3.7's
12V TRIGGER IN jack to a 12-volt trigger output on
the other component with a miniplug cable.
Likewise, to have another component turn on automati-
cally when the TUN-3.7 is turned on, connect the
TUN-3.7's 12V TRIGGER OUT jack to a 12-volt trig-
ger input on the other component with a miniplug cable.
Amplifier, AV receiver, etc.
STANDBY/ON
12 V TRIGGER OUT
STANDBY
ZONE 2 ZONE2 OFF
ZONE 2 LEVEL
PHONES
PURE AUDIO
TUN-3.7
CD player, etc.
12 V
TRIGGER
IN
MASTER VOLUME
TUNING / PRESET
ENTER
RETURN SETUP
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
VIDEO 4 INPUT
MULTl CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 TAPE TUNER CD
VCR 1 VCR 2 SETUP MIC S VIDEO VIDEO L AUDIO R DIGITAL
17