Installation; Connections - Back Side Of Your Dvd Recorder; Connecting To The Antenna; Connecting To A Tv Set - Philips DVDR1000 Instructions For Use Manual

Installation

Connections - back side of your
DVD recorder
- Please refer to your TV set, VCR, Stereo System and
any other User Manual(s) as necessary to make the
optimal connections.
- Do not connect the power until all other connections
are made.
- Do not connect your DVD recorder to your TV set
via your VCR, because the video quality could be
distorted by the copy protection system.
- For better sound reproduction you can connect the
recorder audio outputs to your amplifier, receiver,
stereo system or A/V equipment. For this see
'Connecting to A/V receiver or A/V amplifier'.
Caution:
Do not connect the recorder's audio output to
the phono input of your audio system in order to
avoid damage to your equipment.

Connecting to the antenna

Remove the antenna (aerial) cable plug from your
TV set and insert it into the antenna socket at the
back of the DVD recorder.
Plug one end of the antenna (aerial) cable supplied (1)
into the TV socket on the DVD recorder and the other
end into the antenna input socket on your TV set.

Connecting to a TV set

To obtain the highest possible picture and sound quality
from your TV set it is recommended to use the
connector on both DVD recorder and TV set.
Connect the bottom
the corresponding connector on the TV set, using
the cable supplied (2) as shown in the
SCART
drawing.
TV
EXT 4 EXT 3
If your TV set is not equipped with a
you can connect the DVD recorder with the S-video
(Y/C) sockets.
8 INSTALLATION
SCART
connector (EXT 1) to
SCART
2
AUX- I/0
EXT 2
TO TV I/0
EXT 1
connector,
SCART

S-video (Y/C) connection

Connect the S-video output socket to the
corresponding input socket on the TV set, using the
supplied S-video cable (3).
Connect the audio Left and Right output sockets to
the corresponding sockets on the TV set using the
audio cable supplied (5).
TV
AUX- I/0
EXT 2
EXT 4 EXT 3
TO TV I/0
EXT 1
If your TV set is not equipped with S-video sockets, then
connect the DVD recorder with the CVBS sockets to
your TV set.

Video (CVBS) connection

Connect the Video (CVBS) output socket (yellow)
to the corresponding input socket on the TV set
using the video cable supplied (4).
Connect the audio Left (white) and Right (red)
output sockets to the corresponding sockets on the
TV set using the audio cable supplied (5).
TV
AUX- I/0
EXT 2
EXT 4 EXT 3
TO TV I/0
EXT 1
5
5