Advertisement
Your Curtis ADS System is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
CURTIS
The control displays
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached
screen. It takes approximately 20 minutes to reach setpoint temperature of 200°F.
Control will display
CURTIS
READY TO BREW
PROGRAM MENUS
2
. Press ON/OFF button and the screen will display
when temperature reaches the setpoint (200°F). Unit is now ready to brew.
Curtis
Curtis
Ready
Entering
Programming Mode
Enter Code
- - - -
Program Menus
<-- Select -->
Global Recipes
Non-Brew Prog
<-- Select -->
<-- Select -->
Temperature
Gourmet STD
<-- Select -->
<-- Select -->
Light Roast
Energy Save Mode
<-- Select -->
<-- Select -->
Brew Count Odom
Dark Roast
<-- Select -->
<-- Select -->
Quality Timer
High Yield
<-- Select -->
<-- Select -->
Brew Count Total
Filter Pack
<-- Select -->
<-- Select -->
Decaf
Cold Brew Lock
<-- Select -->
<-- Select -->
Exit
Master Reset
<-- Select -->
<-- Select -->
Service Call
<-- Select -->
Acess Code
<-- Select -->
Banner Name
<-- Select -->
Warmers Auto-Off
<-- Select -->
P-Maintenance
<-- Select -->
Beeper On/Off
<-- Select -->
Drip-Out Mode
<-- Select -->
Warmers Default
<-- Select -->
Display Brew Time
<-- Select -->
Exit
<-- Select -->
<GEMINI TWIN>
. After three seconds,
WILBUR CURTIS
Brew Button Prog
Model Select
<-- Select -->
<-- Select -->
Select Button...
<-- Select -->
ThermoPro Twin
Brew By Volume
<-- Select -->
<-- Select -->
Brew By Time
ThermoPro Single
<-- Select -->
<-- Select -->
Gemini - Twin
Pre-Infusion
<-- Select -->
<-- Select -->
Pulse Brew On/Off
Gemini - Single
<-- Select -->
<-- Select -->
Milano Twin
Bypass On/Off
<-- Select -->
<-- Select -->
Exit
Milano Single
<-- Select -->
<-- Select -->
Gemini - Twin IF
<-- Select -->
Gemini - Single IF
<-- Select -->
IMPORTANT NOTE:
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
SELECTION or ENTER to save new parameter
Scroll RIGHT
CURTIS
is displayed.
FILLING
CURTIS
will appear on the
HEATING
Exit
<-- Select -->
One Batch
<-- Select -->
Two Batch
<-- Select -->
Three Batch
<-- Select -->
Advertisement
