Using Your Receiver - Insignia NS-R2000 User Manual

Insignia NS-R2000 Stereo Receiver
2 Load two type AAA batteries into the
compartment matching the polarity indicated.
3 Replace the cover.
Note
Remove the batteries if they are not to be used for
a long period of time.
Using the remote control
Use the remote control by pointing it towards the
receiver's remote sensor window. Objects
between the remote control and sensor window
may prevent proper operation.
23' (7m)
Use the remote control within about 23 feet
(7 meters) of the receiver and within 30 degrees
of perpendicular to the front of the receiver.

Using your receiver

Listening to a program
To listen to a program:
1 Press the POWER button on the
2 Press the POWER ON button on the remote
www.insignia-products.com
Caution
• Do not expose the remote control to shock. In
addition, do not expose the remote control to
liquids, and do not place in an area with high
humidity.
• Do not place the remote control under direct
sunlight. The heat may cause deformation of
the remote control.
• The remote control may not work properly if the
remote sensor window of the receiver is under
direct sunlight or strong lighting. In such a
case, change the angle of the lighting or
receiver, or operate the remote control closer to
the remote sensor window.
Tip
The following settings are stored in memory
before the receiver is turned off:
• INPUT SELECTOR settings
• Preset stations.
If the electricity fails or the AC power cord is
unplugged for more than two weeks, your memory
is cleared.
receiver to put the receiver in
Standby mode. The STANDBY
indicator lights up.
Tip
You can turn the receiver off by pressing the
POWER button on the receiver while it is in
Standby mode.
control to turn the receiver on.
OR
Tip
You can put the receiver in Standby mode by
pressing the STANDBY button on the remote
control when the receiver is on.
Tip
With the receiver in Standby mode, you can also
turn the power on by pressing an Input Selector
button.
7