Listening To Radio Broadcasts; Adjusting The Sound Volume Balance - Insignia NS-R2000 User Manual

Insignia NS-R2000 Stereo Receiver
2 Within the tone mode, press the
adjust the tone.
Note
• If the tone display disappears, start again from
step 1.
• When pressing the TREBLE up/down or BASS
up/down buttons, you can skip step 1.
• Extreme settings at high volume may damage
your speakers.
• In general, the bass and treble levels are
adjusted to 0.
3 Press the TONE DIRECT button to listen to a
program without the tone effect.
Note
• TON DIR is displayed, DIRECT lights up and
the sound bypasses the tone circuitry.
• To cancel the tone direct function, press this
button again. TON CTRL and DIRECT turns
off.

Adjusting the sound volume balance

To adjust the sound volume balance:
1 Press Balance. BAL and the balance level
are displayed for three seconds.
2 Adjust the sound volume balance between
the left and right speakers.
Note
• If the balance display disappears, start again
from step 1.
• In general, the balance levels are adjusted to 0.
or to
OR
www.insignia-products.com

Listening to radio broadcasts

Auto tuning
To auto tune a radio station:
1 Press TUNER on the receiver or FM/AM on
the remote control to select the band.
OR
Item Description
1 Band
2 Frequency
Each time this button is pressed, the band
changes from AM to FM, and vice versa.
When the tuner is selected by pressing the
TUNER or the FM/AM button, you can select
the band by pressing the BAND button on the
front panel as well.
2 Press T/P MODE to select the tuning mode.
OR
Note
Each time this button is pressed, the mode
changes as follows:
• TUNING mode—PRESET turns off.
• PRESET mode—PRESET lights up..
2
1
9