Installing Batteries; Using The Remote Control; Using Your Receiver; Listening To Your Receiver - Insignia NS-R2001 User Manual

Insignia NS-R2001 AM/FM Stereo Receiver
To connect your headphones:
• Insert the headphone plug into the headphone
jack on the receiver.
Note
To hear sound from the headphones, make sure the
SPEAKER A and SPEAKER B buttons on the remote
control or the Speaker A/B button on the receiver
are set to off.
Connecting the power
To connect your receiver to power:
• Plug the power cord into an AC outlet.

Installing batteries

Caution
Do not use Ni-Cd rechargeable batteries in this
remote control.
Remove the batteries if they are not to be used for an
extended period of time.
To install the batteries:
1 Remove the cover.
2 Insert two AAA batteries into the compartment
matching the polarity indicated.
3 Replace the cover.

Using the remote control

Use the remote control by pointing it towards the
receiver's remote sensor window. Objects between
the remote control and sensor window may
prevent proper operation.
23' (7m)
www.insigniaproducts.com
Use the remote control within about 23 feet
(7 meters) of the receiver and within 30 degrees of
perpendicular to the front of the receiver.
Cautions
• Do not expose the remote control to shock. In
addition, do not expose the remote control to
liquids, and do not place in an area with high
humidity.
• Do not place the remote control under direct
sunlight. The heat may cause deformation of
the remote control.
• The remote control may not work properly if the
remote sensor window of the receiver is under
direct sunlight or strong lighting. In such a case,
change the angle of the lighting or receiver, or
operate the remote control closer to the remote
sensor window.

Using your receiver

Tips
The following settings are stored in memory before
the receiver is turned off:
• INPUT SELECTOR settings
• Preset stations.
If the electricity fails or the AC power cord is
unplugged for more than a week, your memory is
cleared.

Listening to your receiver

To listen to your receiver:
1 Press the POWER button on the
receiver to put the receiver in Standby
mode. The STANDBY indicator lights
blue.
2 Press the POWER ON button on the
remote control or the ON/STANDBY
button on the receiver to turn the
receiver on.
OR
Tip
You can put the receiver in Standby mode by
pressing the STANDBY button on the remote control
when the receiver is on.
With the receiver in Standby mode, you can also turn
the power on by pressing an Input Selector button
on the remote control.
5