Using The Sleep Timer; Adjusting The Display Brightness; Maintaining; Troubleshooting - Insignia NS-R2001 User Manual

Insignia NS-R2001 AM/FM Stereo Receiver

Using the sleep timer

The sleep timer automatically turns the receiver off
after a specified period of time.
To use the sleep timer:
• Press the SLEEP button to specify the amount of
time you want the receiver to play.
Each time this button is pressed, the time
changes as follows:
• 10 minutes
• 20 minutes
• 30 minutes
• 60 minutes
• 90 minutes
• OFF
Note
While operating the sleep timer, the

Adjusting the display brightness

To adjust the display brightness:
• Press the DIMMER button to specify the
brightness of the display.
Each time this button is pressed, the brightness
changes as follows:

Maintaining

To clean this receiver, wipe with a soft, dry cloth. If
the surfaces are extremely dirty, use a soft cloth
dipped in a soap and water solution or a weak
detergent solution.
• Never use alcohol, paint thinner, or benzine to
clean this receiver.
• Before using a chemically treated cloth, read the
instructions that came with the cloth carefully.

Troubleshooting

If a problem occurs, run through the table below
before contacting Insignia.
If the problem persists, attempt to solve it by
switching the receiver off and on again. If this fails
to resolve the problem, contact Insignia. Under no
circumstances should you attempt to repair the
receiver yourself as this could void the warranty.
Category
No power
No sound
lights up.
Stations cannot
be received
Preset stations
cannot be
received
Poor FM
reception
www.insigniaproducts.com
• ON
• dimmer
• OFF
Note
If the display is off, pressing any button turns the
display on.
Problem Possible Solution
• The AC power cord is • Connect the cord securely.
• Check the outlet using a lamp or
disconnected.
• Poor connection at AC
wall outlet or the outlet
is inactive.
• The speaker cords are • Check the speaker connections.
disconnected. • Adjust the volume.
• Press the MUTE button to cancel
• The volume is adjusted
too low.
• The MUTE button on the
• Turn on one or both speakers.
remote control is pressed • Select the desired input source
to ON.
• Speakers are not • Make connections correctly.
switched on.
• Incorrect selection of the
input source.
• Incorrect connections
between the
components.
• No antenna is connected. • Connect an antenna.
• The desired station • Tune in the desired station
frequency is not tuned in.
• The antenna is in wrong • Move the antenna and retry
position.
• An incorrect station • Memorize the correct station
frequency has been
memorized. • Memorize the stations again.
• The memorized stations
are cleared.
• No antenna is connected. • Connect an antenna.
• The antenna is not • Change the position of the
positioned for the best
reception.
another appliance.
the muting effect.
correctly.
frequency.
tuning.
frequency.
antenna.
11