Automatic Code Searching; Learning Set Up; Troubleshooting - Flipper LC Two Device Universal Instruction Manual

Hide thumbs

Table of Contents

Enlarged version

Automatic Code Searching:

This method automatically sends a group of codes until

your device turns OFF. Start with either TV or STB ON.

1. Press and hold TV or STB. The light will flash once

then stay solid. Release the key.

2. Press and release the

will send 10-15 codes to your TV or STB. The indicator

light flashes quickly when sending, and turns solid

when complete.

3. If your TV or STB turns OFF, the code is in that group.

If the device did not turn off, repeat until your device

turns off.

4. Once your device turns off, wait until the indicator

light stops flashing, then press and release the

Channel Down

button to send one code at a time

until your device turns

5. Once the device turns ON, press TV or STB to set and

try your device. If all buttons do not work, repeat.

Note: Some devices share codes with others. As a result, it

is possible that a code matches some but not all of your

device's functions. If this happens, repeat the process

until the correct code controls all of your device's function.

Learning Set Up:

Flipper remote can learn function signals from your

existing remote control. This allows you to copy the

signals from your current remote into the Flipper

remote. Each key is programmed separately. TV, STB,

and ADD do not learn functions.

Note: Favorite channel mode may not work with Learning

set up.

1. Press and hold the TV or STB button and the

button. The indicator will flash once, then remain

flashing. Release the keys.

2. Face your existing remote control's signal transmitter

(on the front) to the Flipper remote transmitter, with

3-5cm gap in between the remotes.

3. Press and release the key on Flipper remote control

that you want to program from your other remote.

ON/OFF

button. The remote

ON.

ON/OFF

The

light will turn solid. Each key is

indicator

programmed separately.

4. Press and release the same key from your existing

device remote until you see the light on the Flipper

remote start flashing again. The learning process for

that key is done.

5. Keep repeating step 1-4 until you learn all the keys

you want.

6. Press the TV or STB button to set the remote.

7. Check the buttons to see if they learned the correct

signal. If not, repeat the process as needed until all

buttons learn the desired function.

Note: The remote can learn functions for any IR remote

control, including a stereo.

Troubleshooting

If you are experiencing difficulties with your remote

control, remember these helpful hints:

1. Make sure the remote is unlocked, by pressing TV,

ADD or STB. The light will flash once, then turn solid.

Then enter 956. The light will flash twice.

2. Check to see if you are in Favorites mode or regular

mode. Press and hold DEL and dash - until the light

flashes twice and turns off. This will enter or exit

favorite channel mode.

3. Press TV and make sure the remote is controlling

your TV. If not, reset the remote by going to Step 1 in

the recommended set up.

4. Press STB and make sure the remote is controlling

your STB. If not, reset the remote by going to Step 2 in

the recommended set up.

5. Restore the original factory settings. Press and hold

ADD until the light flashes once then turns solid, then

enter 954. The light will be solid, then flash twice. If

settings remain in the remote, also do the same with

TV and STB.

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents