Introduction; Functions; Setup; Step 1: Tv Set Up - Flipper LC Two Device Universal Instruction Manual

2. Please finish the battery installation within 5
otherwise the programmed codes Will be lost. Do not
press any key during installation.
3. Remove the batteries if you do not plan to use the
remote for a long period of time to prevent electrolyte
leaking. If leaking occurs, clean the contaminated area
of the battery compartment and replace the old
batteries with new ones.

Introduction

Thank you for your purchase of the Flipper two device
remote control. Flipper is designed for use with your
Television and Set Top Box (STB). STB's are Cable,
Satellite, and Digital TV (DTV) receiver boxes.
hi
Flipper is preset to work with most Motorola STBs.
Ease of Use
Flipper remote operates both your TV and STB using a
minimum number of buttons.
Favorite Channels
You can program up to 30 of your favorite channels. When
activated, the Channel Up/Down
through these channels. This feature does not change
the channel settings of your TV, STB, or other remote
controls.
Dual Mode
In Dual Mode, the ON/OFF
the TV and STB; Channel Up/Down
controls the channels on the STB; and
controls the TV, eliminating the need to press a button to
switch devices.
Lock
This feature "Locks" the settings of the remote, including
favorite channels, and dual mode, and prevents accidental
reprogramming.

Functions

ON/OFF: controls both the TV and STB.
Press MUTE once to turn the sound on or off.
2
minutes
will only advance
button powers on and off both
and the 0-9 keypad
Volume Up/Down
,

Setup

Please follow these step-by-step instructions for the
initial set-up. Remember to use new AAA batteries for
best results.
hi
If you receive your TV stations through an STB, please
note how your TV is connected to the STB. Newer TVs are
connected through an AV input option, such as Video 1 or
2, or Antenna 1 or 2. Older TVs may be set to channel 3 or
4. This will allow you to easily reset the TV if you
accidentally change your Tv's channel during set up.

Step 1: TV set up

Locate the 3-digit code for your TV brand in the code list.
hi
1.
First, 'prime' the remote. Press and hold ADD until the light
flashes once then turns solid. Then enter 954. The light stays
solid then flashes twice.
Channel Up/Down: Controls the STB
channels.
Volume Up / Down: Controls the TV
volume.
0-9 located under the sliding door, are
for set up and channel entry.
"Dash" is used for DTV channel entry.
LC is for "Last Channel" – returns to the
last channel you are viewing.
TV and STB buttons are used to set up
your devices.
ADD and DEL buttons are used to set
up favorite channels.
Indicator light - flashes during set up
and when the remote is used.
3