Flipper LC Two Device Universal Instruction Manual page 3

2. Press and hold the TV set-up key. The indicator light at
the top of the remote will flash once then turn solid.
Release the key.
Note: If you do not press any key more than 30 seconds,
the remote will exit the program.
hi
3. Enter the first 3-digit code for your TV using the 0-9
key pad. If the code is entered correctly, the light will
turn off. If the light stays on, please try again.
hi
4. Try the remote to see if it controls the TV by pressing
the ON/OFF key and
hi
5. If the remote is adjusting your TV, go to Step 2.
hi
6. If the remote does not adjust your TV, repeat the
process using the next 3-digit code listed for your TV
brand until the remote works.
Note: If you are unable to find a working code, see "Other
Set Up Options."
hi
hi
The code for my TV is ______.
Step 2: Set Top Box (STB)
If you are using a TV without a STB, go to Step 3.
hi
Flipper is preset to Motorola cable STBs. It may not work
all Motorola STBs, however. If your STB is manufactured
by Motorola, press STB once (the light will flash) and see
if Flipper works your STB. If yes, go to Step 3. If not,
follow the set up instructions in Step 1: TV, except find
your STB code, and press STB instead of TV in # 1.
h
i
The code for my STB is ______.
Step 3: Favorite Channels
Setting Favorite Channels is optional. If you do not want
a favorite channel list, go to
You can program up to 30 of your favorite channels.
When set, Channel Up/Down
Favorite Channels. The 0-9 keypad allows you to key in
any available channel. Programming favorites does not
change the settings on your STB or other remote controls.
4
Volume Up/Down .
Step 4 .
only scrolls through your
Note: When advancing through your favorite channels
using the Channel Up/Down
the channel to switch before pressing the button
again.
hi
Make a list:
Make a list of your Favorite Channels. The channels will
advance in the order they are entered. For instance, if
you program channels 225, 125, 57, and then 563, the
Channel Up/Down will memorize them in that order
and advance as 225, 125, 57, 563. Flipper does NOT
place channels in numeric order.
hi
hi
Channel Format:
STBs and TVs generally use a three or four digit channel
entry system, 000 or 0000. To enter channels, use 0's as
a place holder. For instance, enter channel 7 as 007
(three digit) or 0007 (four digit). For channel 22, enter
as 022 or 0022. If your TV or STB requires an Enter key
to change channels, please see "Channel Entry Options."
hi
hi
DTV channel format:
hi
hi
Please consult your DTV manual. Use the dash "-"
button, if needed. Some DTVs do not use a dash, and
instead may enter channels in different formats, such as
401 for channel 4-1, or 0301 for channel 30-1.
If using a newer TV with an over the air digital turner,
you may need to learn the dash key from your existing
remote. See "Learning Set Up"
hi
hi
Adding Favorites:
hi
hi
I
The instructions below assume that you are
programming Favorites to work with an STB device. If
you are using a TV without a STB, substitute the TV key
for the STB key.
hi
1. Press STB then ADD. The indicator light will flash
once then turn solid. Release both buttons.
hi
2. Key in the first channel and press the ADD button,
key in the next channel and then ADD, and continue
until all channels are added. The light will flash one
time for each digit.
buttons, please allow
5