Stb Only; Channel Entry Options; Other Set-Up Options - Flipper LC Two Device Universal Instruction Manual

2. Face your existing TV remote control's signal
transmitter (on the front) to the Flipper remote
control transmitter, with 3-5cm gap in between the
remotes.
3. Press and release the
control. The indicator light will turn solid.
hi
4. Press and release the
existing remote control. The indicator light on Flipper
remote should start flashing again.
hi
5. Press STB to save the setting.
hi
6. Enter Dual Mode by pressing and releasing ADD. The
light will flash once.
hi
7. Try the buttons. ON/OFF
Channel Up/Down should control the STB, and
Volume Up/Down should control the TV. If not,
repeat the process.
hi
8. If you want to Lock, use ADD for Dual Mode in Step 5.
hi
Note: Replacing the STB's ON / OFF signal with the TV's
Volume key deactivates the STB's ON / OFF signal,
so that only the TV will turn On and Off.
hi

STB Only:

Press STB. The indicator light will flash once. The
ON/OFF will control your STB;
control the STB, and the
control your TV.
hi
If Volume Up/Down does not control your TV, then
follow the instructions above under TV Only, except in
#1, use the TV set up key instead of the STB key, and
follow the rest of the instructions, including Dual Mode.
This will deactivate the TV's ON / OFF signal, so that
only the STB turns on and off, while the
Up/Down will control the STB, and
should control your TV
Ch annel En tr y Op tions
Some TV / STBs may change channels faster if an ending
signal is sent, such as OK/SELECT or ENTER.
hi
Flipper does not send an ending signal in favorite channel
mode. If you require an ending signal, please follow the
8
ON/OFF key on Flipper remote
Volume Down key for your Tv's
should control the TV only,
Channel Up/Down
Volume Up/Down should
Channel
Volume Up/Down
instructions below.
hi
hi
Note: If you are using the favorite channel mode with a TV
only, use TV instead of STB:
1. Press and hold the
button at the same time. The indicator light will flash
once, then remain flashing. Release both buttons.
hi
2. Face your existing remote control's signal transmitter
(on the front) to the Flipper remote control
transmitter, with 3-5cm gap in between the remotes.
hi
3. Press and release the dash - key on Flipper remote.
The indicator light should turn solid.
hi
4. Press and release the button from your existing
remote that sends the best ending signal, usually
ENTER or OK/SELECT. The indicator light on the
Flipper remote should start flashing again.
hi
5. Press STB to save the setting. The dash - is now your
ENTER key.
hi
6. Test the remote to see if the ending signal is 'learned'
by pressing dash - and making sure it does the same
function as your existing remote. If not, repeat the
will process.
hi
7. In favorite channel mode, add channels by following
the set up instructions above. Then, enter channels
with the dash - / Enter. Example: 7 dash - ADD; 23
dash - ADD, etc.
hi
Note: STB's generally do not require an enter signal. It is
recommended that the enter signal is not used when
entering three and four digit numbers.

Other Set-up Options

It is strongly recommended that you use the set up
instructions
However, there may be instances where your device is
not in the code list. If you were not able to find the codes
for your device using the recommended process, try one
of these two methods.
hi
STB button and then the
above to set up your remote control.
ON/OFF
9