Assembly And Adjustments - King Canada KC-5LS Instruction Manual

ASSEMBLY & ADJUSTMENTS
Warning! For your own safety, do not connect the log splitter to the power
source until the machine is completely assembled and you have read and
understood the entire instruction manual.
Warning! For your own safety, never forget to bolt the support leg to the
log splitter. Lift the log splitter by the handles at both ends and place it on
a 23" - 30" high, stable, flat and level work surface.
Warning! Never use the log splitter if it is not in perfect order or if it needs
servicing. Before starting work, check correct functioning of all the safety
devices (power button).
Assembling Wheels
FIGURE 4
Before operating the log splitter, it is necessary to fit both wheels on the
supporting shaft. Slide a wheel (B) Fig.4 onto the shaft (A), block it using
the large washer (C), and fasten using the nylon hex. nut (D). Repete on
the other side.
Assembling the Supporting Leg
Assemble the supporting leg (A) Fig.5 on the machine body as shown
using two washers, spring washers and hex. bolts.
FIGURE 5
Assembling Control Level Knob and Guard
Screw the rubber knob (A) Fig.6 onto the hydraulic control lever shaft. Use
two washers, spring washers and hex. bolts to fasten the safety guard (B)
on the supporting bracket to protect the hydraulic control lever.
FIGURE 6