Hitachi DS 14DVB Technical And Service Manual page 15

(c) Install the Click Spring [5] and the Cap [4] to the assembly reassembled in step (b). (See Fig. 9.)
(i) Insert the ridge and the projections of the Click Spring [5] into the holes of the Cap [4].
(ii) When the Nut [6] is screwed in the Front Case [9] about one and a quarter turns, the three projections of
the Nut [6] and the marking of the Rear Case [17] are positioned as shown in Fig. 9. Mount the Cap [4]
aligning the ridge of the Click Spring [5] with the three projections of the Nut [6].
Click Spring [5]
Cap [4]
(d) Install the Shift Arm [19] into the assembly reassembled in step (c).
With the ridge at the Shift Arm [19] facing the Motor [28] side, first install them on the unmarked side of
the assembly reassembled in step (c). Then insert the projections on the Shift Arm [19] into the holes in
the Rear Case [17] and make sure that the projections are fitted into the grooves in the Slide Ring Gear
[20] mounted within the Rear Case [17]. (See Fig. 10.)
Recess
Ridge
Projections
--- 13 ---
Projection
Projection
Fig. 8
Three projections of the Nut [6]
Marking of the
Rear Case [17]
Holes
Fig. 9
[26]