Schumacher Electric SE-2254 Owner's Manual page 17

Schumacher electric manual battery charger owner's manual
Hide thumbs Also See for SE-2254:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
Ammeter reads less than
selected charge rate when
charging a discharged
battery
The charger is making an
audible clicking sound.
Charger makes a loud buzz
or hum.
Short or no start cycle when
cranking engine.
POSSIBLE CAUSE
Extension cord is too long or
wire gauge is too small.
Weak cell or sulfated plate in
battery.
Battery is only partially
discharged.
Circuit breaker is cycling.
Battery is defective.
Shorted battery cables or
clips.
Severely discharged battery,
but otherwise it is a good
battery.
Reverse connections at
battery.
Transformer laminations
vibrate (buzz).
Shorted Diode Assembly or
Output Rectifier Assembly
(hum).
Drawing more than the
engine start rate
Failure to wait 3 minutes (180
seconds) between cranks.
Clips are not making a good
connection.
AC cord and/or extension
cord is loose.
No power at receptacle.
13
REASON/SOLUTION
Use a shorter or heavier
gauge extension cord.
A sulfated battery will
eventually take a normal
charge if left connected. If the
battery will not take a charge,
have it checked.
Continue to charge the
battery.
The settings may be wrong.
Check the charger settings.
Have the battery checked.
Circuit breaker cycles when
current draw is too high.
Check for shorted cables or
clips and replace if necessary.
The battery may not want to
accept a charge due to a run-
down state. Allow charging to
continue until battery has a
chance to recover sufficiently
to take a charge. If more than
20 minutes, stop charging and
have the battery checked.
Shut the charger off and
correct the lead connections.
No problem, this is a normal
condition.
Have charger checked by a
qualified technician.
Crank time varies with the
amount of current drawn. If
cranking draws more than the
engine start rate, crank time
may be less than 3 seconds.
Wait 3 minutes of rest time
before the next crank.
Check for poor connection at
battery and frame.
Check power cord and
extension cord for loose fitting
plug.
Check for open fuse or circuit
breaker supplying A.C. outlet.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Se-2352Se-3000Se-4020Se-4022Se-6030Se-8050

Table of Contents