Schumacher Electric SE-2352 Owner's Manual

Schumacher Electric SE-2352 Owner's Manual

Manual battery charger
Hide thumbs Also See for SE-2352:

Advertisement

Models:
SE-2352, SE-3000, SE-3612, SE-4020,
SE-4022, SE-6030, SE-8050
Manual Battery Charger
PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE. This manual
will explain how to use the battery charger safely and effectively. Please read and follow these
instructions and precautions carefully.
SE-4020
OWNERS MANUAL

Advertisement

Table of Contents
loading

Summary of Contents for Schumacher Electric SE-2352

  • Page 1 OWNERS MANUAL Models: SE-2352, SE-3000, SE-3612, SE-4020, SE-4022, SE-6030, SE-8050 Manual Battery Charger SE-4020 PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE. This manual will explain how to use the battery charger safely and effectively. Please read and follow these...
  • Page 2: Table Of Contents

    CONTENTS IMPORTANT SAFETY INSTRUCTIONS ..................4 PERSONAL SAFETY PRECAUTIONS ..................4 PREPARING TO CHARGE ......................5 CHARGER LOCATION ........................5 DC CONNECTION PRECAUTIONS ...................5 FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE .......5 FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE ........6 GROUNDING AND AC POWER CORD CONNECTIONS ............6 ASSEMBLY INSTRUCTIONS ......................6 CONTROL PANEL ........................7 OPERATING INSTRUCTIONS ....................8...
  • Page 3: Important Safety Instructions

    1. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS. 1.1 SAVE THESE INSTRUCTIONS – 1.8 Do not disassemble charger; take it to This manual contains important safety a qualified serviceman when service or and operating instructions. repair is required. Incorrect reassembly may result in a risk of electric shock or fire. 1.2 Do not expose the charger to rain or snow.
  • Page 4: Preparing To Charge

    3. PREPARING TO CHARGE 3.1 If necessary to remove battery from battery without removable cell caps, such vehicle to charge, always remove as valve regulated lead acid batteries, grounded terminal from battery first. Make carefully follow manufacturer’s recharging sure all accessories in the vehicle are off, instructions.
  • Page 5: Follow These Steps When Battery Is Outside Vehicle

    7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE A SPARK NEAR THE BATTERY MAY connect NEGATIVE (BLACK) charger clip CAUSE A BATTERY EXPLOSION. TO to free end of cable. REDUCE THE RISK OF A SPARK NEAR 7.5 Do not face battery when making final THE BATTERY: connection.
  • Page 6: Control Panel

    As a battery takes Always use in combination with a battery. on a charge, it draws less current from TIMER (Not applicable for SE-2352) the charger. Correspondingly, the meter The timer allows you to set a specified will show less current being drawn by the time for charging.
  • Page 7: Operating Instructions

    #2 or #3) in the appropriate position. 9. Set the timer to the charge time (does 7. Set the timer to the charge time (does not apply to SE-2352); MONITOR THE not apply to SE-2352); MONITOR THE CHARGER AND THE BATTERY.
  • Page 8 (6V or 12V) for your switch from OFF to the HOLD position battery. (does not apply to SE-2352). 2. Set the timer to the OFF position. 4. With the charger plugged in and 3. Connect the battery to the charger as connected to the battery of the specified earlier.
  • Page 9: Calculating Charge Time

    • Yellow or Red, but the needle remains switch and note the voltmeter reaction. steady – Indicates that the battery Voltage recovery into the green or above capacity is not satisfactory. The battery within seconds indicates a defective may be either defective or not fully battery.
  • Page 10: Maintenance And Care

    13. MAINTENANCE AND CARE A minimal amount of care can keep your • Coil the input and output cords neatly battery charger working properly for years. when storing the charger. This will help prevent accidental damage to the cords • Clean the clamps each time you are and charger.
  • Page 11 PROBLEM POSSIBLE CAUSE REASON/SOLUTION The charger is Circuit breaker is cycling. The settings may be wrong. Check making an audible the charger settings. clicking sound. Battery is defective. Have the battery checked. Shorted battery cables Circuit breaker cycles when current or clamps.

This manual is also suitable for:

Se-3000Se-4022Se-3612Se-6030Se-8050Se-4020

Table of Contents