1
2
007222
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Insert the top end of slotted bit screwdriver into the notch
in the tool and remove the holder cap cover by lifting it
up.
1
007226
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
007223
1. Exhaust vent
2. Inhalation vent
1. Limit mark
1
1. Holder cap
cover
2. Screwdriver
2
1. Brush holder
cap
2. Screwdriver
Reinstall the holder cap cover on the tool.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Wheel guard (Wheel cover) For depressed center
•
wheel / Multi disc
Wheel guard (Wheel cover) For abrasive cut-off
•
wheel / diamond wheel
Depressed center wheels
•
Abrasive cut-off wheels
•
Multi discs
•
Diamond wheels
•
Wire cup brushes
•
Wire bevel brush 85
•
Abrasive discs
•
Inner flange
•
Lock nut For depressed center wheel / abrasive
•
cut-off wheel / multi disc / diamond wheel
Lock nut For abrasive disc
•
Lock nut wrench
•
Side grip
•
Various type of Makita genuine batteries and
•
chargers
11
or
attachments
Only use
accessory or
are