Troubleshooting - Ryobi RCP254G Operator's Manual

PROBLEM
Engine fails to start.
Engine hard to start.
Engine lacks power.
Engine overheats.

TROUBLESHOOTING

POSSIBLE CAUSE
Engine switch is in the OFF position.
No fuel in tank.
Spark plug shorted or fouled.
Spark plug is broken ( porcelain
cracked or electrodes broken).
Ignition lead wire shorted, broken, or
disconnected from spark plug.
Ignition inoperative.
Water in petrol or stale fuel mixture.
Too much oil in fuel mixture.
Engine is under or over choked.
Weak spark at spark plug.
Move switch to RUN (I) position.
Fill tank.
Replace spark plug.
Replace spark plug.
Replace lead wire or attach to spark plug.
Contact authorised service centre.
Contact authorised service centre.
Mix fuel as described in starting instructions.
14
REMEDY