Setting The Water Softener - Zanussi ZDTS 102 User Manual

Setting the water softener

The water softener removes minerals and salts from the
water supply. Minerals and salts can have bad effect on
the operation of the appliance.
Water hardness is measured in equivalent scales:
• German degrees (dH°).
• French degrees (°TH).
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener manually and elec-
tronically.
Manual adjustment
The appliance is set at the factory at position 2.
1
Electronic adjustment
The water softener is set at the factory at level 5.
6
Water hardness
mmol/l
9,1 - 12,5
7,6 - 9,0
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
< 0,7
2
Set switch to position 1 or
2.
• mmol/l (millimol per litre - international unit for the
hardness of water).
• Clarke.
Adjust the water softener to the water hardness in your
area. If necessary, contact your local water authority.
Clarke manually
64 - 88 2
53 - 63 2
46 - 52 2
36 - 45 2
28 - 35 2
23 - 27 2
18 - 22 1
13 - 17 1
5 - 12 1
< 5 1)
1
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel but-
ton.
4. Release the programme selection/cancel button
when programme indicator light A starts to flash and
programme indicator light B comes on.
5. Wait until programme indicator light B goes off.
– Programme indicator light A starts to flash.
– The end indicator light starts to flash.
6. Press the programme selection/cancel button one
time.
– Programme indicator light A starts to flash.
– The setting function of the water softener is acti-
vated.
– The end indicator light flashes to show the level
of the water softener.
Example: 5 flashes, pause, 5 flashes, pause, etc...
= level 5.
Water hardness setting
electronically
10
9
8
7
6
5
4
3
2
1)
1