Electrical Connection - Zanussi ZDTS 102 User Manual

• Do not put the water inlet hose or the safety valve in
water.
• If the water inlet hose or the safety valve is damaged,
immediately disconnect the mains plug from the mains
socket.
• Only let the Service Force Centre replace the water inlet
hose with safety valve.
Drain hose
1
Connect the water drain
hose to the sink spigot.

Electrical connection

Warning! The manufacturer is not responsible if
you do not follow these safety precautions.
Ground the appliance according to safety precautions.
Make sure that the rated voltage and type of power on the
rating plate agree with the voltage and the power of the
local power supply.
Always use a correctly installed shockproof socket.
Do not use multi-way plugs, connectors and extension
cables. There is a risk of fire.
Do not replace the mains cable yourself. Contact the
Service Force Centre.
max 85 cm
min 40 cm
2
3
The internal diameter must not be smaller than the diam-
eter of the hose.
If you connect the water drain hose to a trap spigot under
the sink, remove the plastic membrane (A). If you do not
remove the membrane, remaining food can cause a block-
age in the drain hose spigot.
Caution! Make sure that the water couplings are
tight to prevent water leakage.
Make sure that the mains plug is accessible after
installation.
Do not pull the mains cable to disconnect the appliance.
Always pull the mains plug.
Warning! The appliance is supplied with a 13 amp
plug attached. Use a 13 amp ASTA approved (BS
1362) fuse if it is necessary to change the fuse in the plug
supplied.
4
15