Table of Contents
Advertisement
Available languages
Available languages
This appliance may be used in offices, hotel guest rooms, bed
•
& breakfast guest rooms, farm guest houses and other similar
accommodation where such use does not exceed (average)
domestic usage levels.
Do not change the specification of this appliance.
•
The operating water pressure (minimum and maximum) must be
•
between 0.5 (0.05) / 10 (1) bar (MPa)
Follow the maximum number of 13 place settings.
•
The appliance door should not be left in an open position to
•
avoid the tripping hazard.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
WARNING: Knives and other utensils with sharp points must
•
be loaded in the basket with their points down or placed in a
horizontal position.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to clean
•
the appliance.
If the appliance has ventilation openings in the base, they must
•
not be covered e.g. by a carpet.
The appliance is to be connected to the water mains using the
•
new supplied hose-sets. Old hose sets must not be reused.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
•
Remove all the packaging.
•
Do not install or use a damaged appliance.
•
Follow the installation instructions supplied with
the appliance.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Do not install or use the appliance where the
temperature is less than 0 °C.
•
Install the appliance in a safe and suitable place
that meets installation requirements.
24
•
Do not use the appliance before installing it in
the built-in structure due to safety manner.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
•
Warning: this appliance is designed to be
installed / connected to a grounding connection
in the building.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Always use a correctly installed shockproof
socket.
Advertisement
Table of Contents
