ProForm Performance 400 C User Manual page 10

6. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Remove and discard the four indicated
Screws (B).
Identify the Left Tray (90) with the writing on the
bottom. Attach the Left Tray with four #8 x 1/2"
Screws (10). Start all four Screws before tight-
ening them. Be careful not to overtighten the
Screws.
Attach the Right Tray (85) in the same way.
7. With the help of a second person, hold the con-
sole assembly near the Left Upright (75).
Connect the Upright Wire (70) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
6
B
7
70
10
10
10
10
90
10
Console
Assembly
B
Console
Assembly
Console
Wire
70
Wire
Tie
85
75