Front seats
Only adjust the seat when the
car is stationary. You could
lose control of the car while
driving. Moving the seat could distract
you or make you press a pedal
unintentionally. Adjust the driver's
seat only when the car is stopped.
Seat adjustment is possible only with
the ignition key in the MAR position.
However, with the door closed , seat
adjustment operation is possible for
4
about 15 seconds after turning the
ignition key to the STOP position and
then for another 15 seconds after the
last operation.
A
B
80
Front seats
Back/forward adjustment
Push control A on the outer side of the
seat forward or back.
WARNING: On vehicles equipped a fire
extinguisher (optional), forward
movement of the passenger seat is
limited in order to prevent
interference with the fire extinguisher.
Height adjustment
Grip control A at the center and push
down or up.
Seat angle adjustment
– Front part of seat: push the front end
of control A up or down.
– Rear part of seat: push the rear end
of control A up or down.
Seat back angle adjustment
Push lever B forward or backward to
bring the seat backrest to raise or
lower the backrest.
Sitting in a reclined position
while the vehicle is in motion
could be dangerous. The
seatback should not be tilted back too
far. The 3-point shoulder/lap belt
must remain firm against the
occupant's body in order to function
properly. Therefore, both the driver's
and passenger's reclining seatbacks
must always be in a fairly upright
position while the vehicle is in motion;
otherwise the 3-point shoulder/lap
belt would not remain firm against the
occupant. Serious injury could result!
Lumbar support adjustment
Push lever B up or down to the most
comfortable position.