Advertisement
CONTROLS AND INDICATORS
POWER/VOLUME KNOB
Press and hold for a few seconds for power on. Press and
hold again for power off. Clockwise rotation increases
volume of received messages.
CHANNEL/MENU CONTROL KNOB
Channel Function: Rotate to scroll through channels.
Your radio can be programmed, by the radio
technician to either stop at the highest and lowest
channels, or for channel rollover.
Menu Function: Press and release to activate the
menu mode, which will allow you to access, Squelch
Setting (SQL), Group Setting (GRP), All Group Scan
(AGS) or One Group Scan (OGS), Scan Key Type
Setting (PRI, SCN, P/S), Back Light Control (BLN= on,
or BLF=off), ANI (ANN=on, ANF=off), Clone Mode
(CLN) and Clone Process.
When finished adjusting the squelch, immediately
press the MENU button to cause the new squelch
setting to be stored in the radio memory. For proper
operation the squelch should be set 5 – 10 digits
higher than the level required for initial muting.
All Group Scan availability requires more than 1
group to be programmed and Type A scan selected.
Some scan key types may not
depending on programming. The ANI mode will not
be available unless activated by the radio technician.
PUSH-TO-TALK BAR (On the Hand Microphone)
Transmit mode (talk mode) is initiated when pressed.
The radio will emit your voice signals on the channel
that appears in the Channel Display.
SCAN BUTTON
Press SCAN to activate Scan operation. For detailed
SCAN
information see the following descriptions of the
different scan modes. Also used in conjunction with
the A/D button to add or delete channels from the
scan list.
be available
1
PRIORITY SCAN ESCAPE
If the radio technician has programmed the radio for this function, the
operator may press the "AUX" button to operate on the last busy
channel. Press the "AUX" button again to revert to priority scan with
the priority channel unchanged.
NOTE:
Conditions when the scan table is automatically reset
(initialized), to original programming, is set by the radio technician.
The user may manually initialize the scan table by pressing the A/D
button for a few seconds (until 2
ANI OPERATION
1. If ANI operation has been activated during initial programming the
radio will transmit the code on the first transmission of a
conversation.
2. If the ANI is activated on a certain channel by the radio technician,
it cannot be deactivated by the user. The ANI may be set on/off by
the user if it is not specifically activated by the technician.
2 TONE DECODE OPERATION
1. If the radio is programmed for 2 tone decode it may be activated,
on channels so programmed, by pressing and holding the menu
button until the second beep is heard.
2. When the radio receives a call with the proper ANI code a series
of quick beeps will be heard. If the call is answered by pressing
the PTT then the decoder will be reset to normal (non ANI)
operation. If the call is not answered a beep will be heard 15
seconds and 30 seconds after the call and then return to ANI
decode mode.
3. The decoder may be also be deactivated by pressing the MON
button or the PTT button.
nd
beep) when not in scan operation.
6
Advertisement
