Advertisement
ATTENTION! The vacuum accessories are packed inside the vacuum tank.
UNPACKING YOUR VACUUM
Remove the entire contents of the carton, please note that most of the accessories are
packed inside the vacuum tank. To access these accessories, pull the cover latches (A) Fig.3 in
an upward then downward motion, remove the tank cover/motor assembly and then remove the
accessories inside the tank.
WARNING! DO NOT CONNECT THE POWER CORD TO THE POWER SOURCE UNTIL THE
FOLLOWING ASSEMBLY AND SET-UP INSTRUCTIONS HAVE BEEN DONE.
CASTER WHEEL ASSEMBLY
Four caster wheels are included and should be assembled to the bottom of the tank.
1) With the tank cover/motor assembly removed, turn the tank upside down. Insert the caster
wheels (A) Fig.4 into the bottom of the tank as shown.
2) Make sure each caster wheel is pushed down all the way, then secure each caster wheel in
place using the supplied screws and a screwdriver.
TOP HANDLE ASSEMBLY
A top carry handle is included and should be assembled to the top of the cover/motor assembly.
1) Place the top handle into position on the cover, please note this handle only fits in one
direction into the handle slots.
2) Make sure the handle (A) Fig.5 is pushed in all the way and secure it into place using the
supplied screws and a screwdriver.
INSTALLING THE CORRECT FILTER AND/OR DUST BAG FOR THE APPLICATION
Before reinstalling the cover/motor assembly on, it is important to determine the desired
cleaning application, wet or dry vacuuming. Each cleaning application requires different filters
and/or dust bag.
When vacuuming dry materials, to ensure proper filtration, the foam filter should be used
when vacuuming coarse materials with low dust for maximum air flow. The re-usable filter can
and should be used together with the foam filter or only install the cartridge filter instead of both
other filters when vacuuming coarse and dusty materials. Place the cover/motor assembly
upside down, slide the foam filter (A) Fig.6 or the cartridge filter over the cage (B). If you
installed the foam filter, then slide the re-usable filter over the foam filter. Now the dust bag (C)
must be installed to the inner portion of the inlet. Fit the dust bag flange over the inner inlet,
taking care not to damage the dust bag.
When vacuuming wet materials, to ensure proper filtration, the foam filter must be installed.
Place the cover/motor assembly upside down, slide the foam filter (A) Fig.6 over the cage (B).
Reposition and secure the cover/motor assembly to the tank with both cover latches.
HOSE, WANDS AND ACCESSORY ASSEMBLY
1) Thread the nut end of the hose (A) Fig.7 to the vacuum inlet (front of the vacuum) and
tighten the hose by turning clockwise, do not overtighten.
2) Assemble the 2 extension wands together and then attach one end of the extension wand
assembly to the hose.
3) Attach either the floor sweep (B) Fig.7 or the crevice tool to the other end of the extension
wand assembly (C).
UNPACKING & ASSEMBLING
YOUR VACUUM
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Advertisement
