Table of Contents
Advertisement
Tick "Show Image" showing image when decoding, otherwise no image
Meanwhile if tick "Keep show last image" after decoding last image will be shown, otherwise no image
Tick "Save Image" after successfully decoding, last image will be named as "cmos-img.bmp" and save in "My Equipment"
Testing
Click "Testing" Figure 4.9 will pop up. When reading barcode, information will be showed in the window.
Help
Click "Help", choose "About Barcode Engine Parameter Configuration" , Figure 4.10 will pop up showing version and
copyright of barcode engine configuration program.
Reading 1D barcode
First, start program "Barcode Engine Parameter Configuration", configure relevant reading parameter on normal and 1D
barcode setting page, save the setting.
Then, adjust the terminal barcode reading angle or the distance between barcode with terminal. Let the width of the scan
line appropriately larger than the width of the barcode (about 4mm), in order to get the best reading.
18
Figure 4.9："Testing"
Figure 4.10："Help"
Advertisement
Table of Contents
Troubleshooting
