Page 1
Teton Grill Company – 3880 Fourth Avenue East – Shakopee, Minnesota, 55379 Stainless Steel Gas Grill Use and Care Guide Model: Classic WARNING: All barbecues and carts are designed for outdoor use only and cannot be installed in or on boats.
Thank you for buying a Teton Classic grill. We know that there are many grilling options available. Our unique designs have been developed to combine the best grilling performance with work of art details. We hope that this combination will enable you to join us in an outdoor lifestyle that allows “LIVING AT ITS PEAK”.
SAFETY INFORMATION TO AVOID PERSONAL INJURY • When properly cared for, your grill will Grease is flammable. Let hot provide safe and reliable service for many grease cool before attempting to years. Abiding by the following safety handle it. Clean the bottom of the instructions can greatly reduce the risk of grill’s firebox often, and do not allow accidents.
SAFETY INFORMATION - continued • using this appliance. Some synthetic Do not use briquettes of any kind fabrics are highly flammable and in the grill. This grill is designed for should not be worn while cooking. use without briquettes. Do not place briquettes on the radiant as this will •...
Page 5
SAFETY INFORMATION - continued Note: LP Gas Cylinder (supplied by others) must be fitted with Overfill Protection Device (OPD). TESTED IN ACCORDANCE WITH ANSI Z21.58A STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY. Check your local building codes for the proper method of installation. In the absence of local codes, use either the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
LIGHTING PRECAUTIONS CAUTION WARNING To protect yourself against the risk of electric Always keep your face and body as far away shock, connect to properly grounded outlets from the burner as possible when lighting. only and keep the extension cord dry and off the ground.
ASSEMBLY INSTRUCTIONS In addition to this manual, this box contains the following materials: • 2 Front Panels for Side Shelves • 2 Side Shelves • 4 steel Flame Tamers • 3 cast iron Cooking Grates • 4 Rifle Casing Style Control Knobs •...
Page 8
ASSEMBLY INSTRUCTIONS (continued) Figure 1 GRILL ASSEMBLY 1. Install the 4 steel Flame Tamers in the grill, above the burners, as shown in Figure 2 below. Make sure the flame tamers rest securely on the locating pins. 2. Handle the cast iron Cooking Grates with care as they can break if dropped. Place the outside grates in place and slide to the edges of the grill.
Page 9
Figure2 CONTROL KNOB INSTALLATION BE SURE GAS IS NOT CONNECTED WHEN INSTALLING CONTROL KNOBS 1. Install the left Control Knob first. Using the supplied 2mm Allen wrench, loosen the set screw so that nothing shows on the inside of the stem slot. Put the knob over the left valve stem. Push the knob down and turn 90 degrees to the left.
GAS HOOK-UP LP GAS HOOK-UP: Total gas consumption (per hour) of the Teton Classic grill with all burners on “IGNITE/HI”: Ensure that the black plastic grommets on the LP cylinder valve are in place and that 48,000 btu/hr the hose does not come into contact with the grease tray or the grill head.
GAS TANK PRECAUTIONS • The maximum size LP tank you should use is Only use the regulator and the hose approximately 12 inches in diameter by 18- assembly supplied with your gas grill. 1/2 inches high. You must use an OPD gas Replacement regulators and hose tank which offers an Overfill Prevention assemblies must be those specified in...
! Warning ! A strong gas smell or the hissing sound of gas indicates a serious problem with your grill or the LP gas tank. Failure to immediately follow the steps below could result in a fire or explosion that could cause serious property damage, personal injury, or death.
Need help?
Do you have a question about the Classic and is the answer not in the manual?
Questions and answers