Page 1
Teton Grill Company – 3880 Fourth Avenue East – Shakopee, Minnesota, 55379 Stainless Steel Gas Grill Use and Care Guide Model: Classic WARNING: All barbecues and carts are designed for outdoor use only and cannot be installed in or on boats.
Thank you for buying a Teton Classic grill. We know that there are many grilling options available. Our unique designs have been developed to combine the best grilling performance with work of art details. We hope that this combination will enable you to join us in an outdoor lifestyle that allows “LIVING AT ITS PEAK”.
SAFETY INFORMATION TO AVOID PERSONAL INJURY • When properly cared for, your grill will Grease is flammable. Let hot provide safe and reliable service for many grease cool before attempting to years. Abiding by the following safety handle it. Clean the bottom of the instructions can greatly reduce the risk of grill’s firebox often, and do not allow accidents.
Page 4
SAFETY INFORMATION - continued • using this appliance. Some synthetic Do not use briquettes of any kind fabrics are highly flammable and in the grill. This grill is designed for should not be worn while cooking. use without briquettes. Do not place briquettes on the radiant as this will •...
Page 5
SAFETY INFORMATION - continued Note: LP Gas Cylinder (supplied by others) must be fitted with Overfill Protection Device (OPD). TESTED IN ACCORDANCE WITH ANSI Z21.58A STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY. Check your local building codes for the proper method of installation. In the absence of local codes, use either the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
LIGHTING PRECAUTIONS CAUTION WARNING To protect yourself against the risk of electric Always keep your face and body as far away shock, connect to properly grounded outlets from the burner as possible when lighting. only and keep the extension cord dry and off the ground.
ASSEMBLY INSTRUCTIONS In addition to this manual, this box contains the following materials: • 2 Front Panels for Side Shelves • 2 Side Shelves • 4 steel Flame Tamers • 3 cast iron Cooking Grates • 4 Rifle Casing Style Control Knobs •...
ASSEMBLY INSTRUCTIONS (continued) Figure 1 GRILL ASSEMBLY 1. Install the 4 steel Flame Tamers in the grill, above the burners, as shown in Figure 2 below. Make sure the flame tamers rest securely on the locating pins. 2. Handle the cast iron Cooking Grates with care as they can break if dropped. Place the outside grates in place and slide to the edges of the grill.
Page 9
Figure2 CONTROL KNOB INSTALLATION BE SURE GAS IS NOT CONNECTED WHEN INSTALLING CONTROL KNOBS 1. Install the left Control Knob first. Using the supplied 2mm Allen wrench, loosen the set screw so that nothing shows on the inside of the stem slot. Put the knob over the left valve stem. Push the knob down and turn 90 degrees to the left.
GAS HOOK-UP LP GAS HOOK-UP: Total gas consumption (per hour) of the Teton Classic grill with all burners on “IGNITE/HI”: Ensure that the black plastic grommets on the LP cylinder valve are in place and that 48,000 btu/hr the hose does not come into contact with the grease tray or the grill head.
GAS TANK PRECAUTIONS • The maximum size LP tank you should use is Only use the regulator and the hose approximately 12 inches in diameter by 18- assembly supplied with your gas grill. 1/2 inches high. You must use an OPD gas Replacement regulators and hose tank which offers an Overfill Prevention assemblies must be those specified in...
! Warning ! A strong gas smell or the hissing sound of gas indicates a serious problem with your grill or the LP gas tank. Failure to immediately follow the steps below could result in a fire or explosion that could cause serious property damage, personal injury, or death.
OPERATING INSTRUCTIONS NOTE: The grill is designed to grill efficiently General use of the grill without the use of lava rocks or briquettes of any kind. Heat is radiated by the steel flame Each main burner is rated at 12,000 BTU/hr. tamers positioned above each burner.
LIGHTING INSTRUCTIONS ! WARNING ! TO LIGHT THE GRILL BY MATCH: To light your gas grill by match, open the lid BEFORE LIGHTING… and light a match. Place the lit match on the match holder as shown in Figure A. Turn the Do not attempt to light the grill if odor of right main burner control knob to the HI gas is present.
CARE AND MAINTENANCE Stainless Steel Grill Burner Cleaning Many of the grill components are made with Ensure the gas supply is off and the knobs non-rusting and non-magnetic stainless steel. are in the OFF position. Make sure the grill is There are many different stainless steel cool.
Page 16
CARE AND MAINTENANCE- continued HOW TO REPLACE THE MAIN BURNER 1. Remove the burner by removing the one hold down screw and lifting burner out. 2. Examine the open end of the new burner. There is a shutter around the outside of the open end held in place with one screw that controls the air used by the burner.
TROUBLESHOOTING A list of common problems and solutions is located on the proceeding pages. PROBLEM SOLUTION When I light the grill it does not -- Make sure the gas is turned ON. immediately ignite. -- Make sure there is a spark while trying to ignite the burner. -- Push in and hold for approximately 5 seconds before turning the knob.
Page 18
The grill takes a long time to -- It normally takes about 10 minutes in order for your grill to preheat. reach a pre-heating temperature of 480°F. Cold weather and wind may effect your preheat time. -- If you are using volcanic rock or briquettes, it can increase the preheat time and maximum temperature.
Teton Classic Gas Grill Parts List DESCRIPTION DESCRIPTION Thermometer Control Panel Hood Valves Hood Side Panel Bezels Handle Manifold Warming Rack Control Knobs Accent Panel Control Rear Panel Panel Firebox Rear Panel Left Front Support Cooking Grate Left Back Support...
GRILLING HINTS The doneness of meat, whether rare, medium, or well done, is affected to a large degree by the thickness of the cut. Expert chefs say it is impossible to cook rare a thin cut of meat. The cooking time is affected by the kind of meat, the size and shape of the cut, the temperature of the meat when cooking begins, and the degree of doneness desired.
Center at: 877-508-3866 or email us at contact@tetongrills.com. If Teton Grill Company confirms the defect and approves the claim, then Teton Grill Company will elect to replace such part without charge. Parts returned to Teton Grill Company must be sent freight...
|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__| Address |__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__| City State Zip Code |__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__| Email Address |__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__| Phone Number Date of Purchase |__|__|__| - |__|__|__| - |__|__|__|__| |__|__|/|__|__|/|__|__|__|__| Serial Number |__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__| Model Number |__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__|__| Mail to: Teton Grill Company 3880 Fourth Avenue East Shakopee, MN 55379...
Need help?
Do you have a question about the Classic and is the answer not in the manual?
Questions and answers