Toro 74621 Operator's Manual page 18

Figure 16
1. Park (brake) position
2. Center unlock position
3. Forward
Using the Smart Speed™ Control
System
The Smart Speed™ Control System lever, located
below the operating position (Figure 17), gives the
operator a choice to drive the machine at two ground
speed ranges, high and low.
Figure 17
1. Smart speed lever
To change speeds:
4. Backward
5. Front of machine
1
G014475
1. Move the motion control levers to neutral and
outward to the park position; disengage the blade
control switch.
WARNING
Removing your hands from the motion control
levers while the machine is in motion can result
in a loss of control causing harm to you or
bystanders.
Always stop the machine and move the motion
control levers to the park position before
adjusting the Smart Speed™ Control System.
2. Adjust the lever to the desired position.
Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion control
levers forward (Figure 16).
To go straight, apply equal pressure to both motion
control levers (Figure 16).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 16).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
18
G008952
Figure 18