Prepare The Hood - Kenmore 233.5580 Series Use & Care / Installation Manual

1. Remove 7" Round Duct Plate from top of hood.
Set duct plate aside - with mounting screws.
2. Remove tape holding Filters in place. Pull down
on filter tabs and lift filters out. Set filters aside.
3. Remove Damper/Duct Connector from inside the
hood. Set connector aside - with mounting screws
and parts bag.
4. Remove Wiring Cover from inside the hood. Set
cover and mounting screw aside.

PREPARE THE HOOD

FILTERS
DAMPER/DUCT
CONNECTOR
WIRING
COVER
7
7" ROUND
DUCT PLATE