Prepare The Hood - Kenmore 31130 Installation Manual

1. Lay the hood on its back on a table.
Remove grease fi lters by lifting the metal latch tab (1),
pushing down on the fi lter (2) and tilting is towards you (3).
NOTE
Use a piece of cardboard to avoid damaging the table or the
hood.
2. Choose the opening:
V :
ERTICAL DISCHARGE
Using a Robertson or a Phillips no. 2 screwdriver, remove
the 4 top metal plate retaining screws in order to clear the
vertical discharge opening (see illustration beside). Discard
the metal plate and its screws.
H :
ORIZONTAL DISCHARGE
In order to ease a retrofi t installation, the horizontal discharge
may be positioned on higher OR on lower back of the hood.
From outside the unit, remove the knockout for the chosen
discharge opening (see illustrations beside).

PREPARE THE HOOD

1
HR0038
9
3
1
2
HD0376
R
ETAINING SCREWS LOCATIONS
HO0142
2
OR OR