Omron CX3 Instruction Manual page 7

8. Connect the airtube; one end to the compressor unit and the other end to the bottom of the medication
tank:
9. Hold the nebuliser in the position as shown below and switch the unit to ON (I) position.
10. When inhaling you should sit upright and relaxed. If you must be treated in bed, support yourself with
pillows so that you are sitting as upright as possible.
The design of this nebuliser kit enables its use in a tilted position. This is especially an advantage for a
person who wants to use the device while lying in bed.
Always be calm and relaxed when you inhale. Breathe in slowly and deeply so that the medication can
reach deep into the bronchial tubes. Hold your breath for a short time, then breathe out slowly while
removing the mouthpiece from your mouth. Do not try to breathe too quickly. Pause when you feel like
having a rest.
Breathe in:
11. When the treatment is finished, set the OFF/ON switch (O/I) to the OFF (O) position and disconnect
the power plug from the wall socket.
12. Clean the nebuliser kit (refer to the cleaning instructions).
Note: If a mask (optional accessory) is used, remove the mouthpiece from the nebuliser cap and connect
the mask instead. Place it with the rubber band onto the face so that the mask will enclose the nose and the
mouth. The tightness of the rubber band can be adjusted. The mask has openings which will enable unres-
trained breathing.
6
Breathe out:
English