Installation - VINCENT CD-S7 Instructions For Use Manual

Hybrid cd player
Table of Contents

Advertisement

Available languages

Available languages

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the pro-
tective plastic caps must be removed
from all the connections used at the
rear of the unit.
RCA connections
Mechanically identical RCA
plugs are available for analogue and digital out-
puts. Make sure that you do not get these connec-
tions confused during installation!
Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right chan-
nel, black or white for the left channel.
A set of headphones equipped with a 6.3 mm jack can be plugged into the "PHONES" socket (12) on the front
of the appliance.
All headphones with an impedance of between 32 Ohm and 600 Ohm may be used. Unsuitable headphones
with too low impedance may damage the amplifier or produce such unexpectedly loud volume that your hearing
may be damaged. The volume should be reduced (13) for safety reasons before a set of phones is connected.
CONNECTION OF THE POWER CABLE
Check that the power supply to your home is appropriate to the device. The required voltage and frequency can
be read on the back of the device beside the socket for the mains. If the power supply is appropriate, push the
inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device. Connect
the other end of the mains cable to a mains socket.
Vincent
32

INSTALLATION

DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1
2
O UT PU T
OU
CONNECTING HEADPHONES
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- wrong -
- correct -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents