Dodge Grand Caravan 2011 Owner's Manual page 97

WARNING!
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchor positions directly behind
the child seat to secure a child restraint top tether
strap.
Installing the Child Restraint Using The Vehicle
Seat Belts
The seat belts in the passenger seating positions are
equipped with an Automatic Locking Retractor to secure
a Child Restraint System (CRS). These types of seat belts
are designed to keep the lap portion of the seat belt tight
around the child restraint so that it is not necessary to use
a locking clip. The ALR will make a ratcheting noise if
you extract the entire belt from the retractor and then
allow the belt to retract into the retractor. For additional
information on ALR, refer to "Automatic Locking Mode"
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 95
description under "Seat Belts In Passenger Seating Posi-
tions" section. The chart below defines the seating posi-
tions with an Automatic Locking Retractor (ALR) or a
cinching latch plate.
Driver
CRS Lock
First Row N/A
Second Row ALR
Third Row ALR
• N/A — Not Applicable
• ALR — Automatic Locking Retractor
Installing a Child Restraint with an ALR:
1. To install a child restraint with ALR, first, pull enough
of the seat belt webbing from the retractor to route it
through the belt path of the child restraint. Slide the latch
plate into the buckle until you hear a "click." Next,
extract all the seat belt webbing out of the retractor and
Center Passenger
CRS Lock CRS Lock
N/A ALR
N/A ALR
Cinch ALR
2