Dodge Grand Caravan 2011 Owner's Manual page 198

196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
• After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 "Programming A Rolling Code
System."
• Press and hold the just-trained HomeLink button and
observe the indicator light.
If the indicator light stays on constantly, programming
is complete and the garage door (or device) should
activate when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to "Programming
A Rolling Code System."
Programming A Rolling Code
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor. It is
NOT the button normally used to open and close the
door.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button