Panasonic BL-C30C Operating Instructions Manual page 39

Notes
• Some wireless devices do not support the WEP 152 bit.
• The camera supports only the open system authentication. If the wireless
router or access point is set to shared key authentication, set it to auto or
open system.
4.
Click [Save] when finished.
• New settings are saved.
• When finished, "Success!" is displayed.
5.
Click [Go to Wireless configuration page].
• The Wireless page is displayed.
6.
Set the switch to WIRELESS.
Notes
• Encryption is a help to protect data within wireless LAN from third parties.
• Enter both the MAC addresses for the camera itself and the camera's
wireless module to enable the MAC address filtering feature on the
wireless router. The wireless module MAC address is one value higher
than the camera MAC address.
• It takes about 1 minute for the new settings to be effective.
• It is not possible to access the camera simultaneously by both wired and
wireless connection.
• To communicate using wireless connection, set up the camera by using
wired connection and set the switch from wired to wireless as shown
below.
• Even if the camera is set to wired connection, it emits electrical waves for
about 5 minutes after the power has been on. During this time, the router's
wireless indicator is on or blinking. Electrical waves will stop being
transmitted after about 5 minutes.
< Bottom >
Switch
• When you switch wired to wireless or vice versa, restart the camera. Some
routers also may need to be restarted after switching.
WIRED
WIRELESS
SANS FIL
CÂBLÉ
Operating Instructions
39