Maintenance; Changing The Internal Light; Care When Handling; Installation - Logik LWC32B10 Instruction Manual

Wine cooler
Table of Contents

Advertisement

Maintenance

Changing the Internal Light

1. Before carrying out the bulb replacement always switch the internal light to OFF, then
disconnect the mains supply.
2. Hold and unscrew the light bulb cover.
3. Remove the plastic light bulb cover.
4. Remove the old bulb by unscrewing in an
anti-clockwise direction.
5. Replace with a new bulb (10W SES). Please make
sure that it is secure in the bulb cover.
6. Refit the light bulb cover and reconnect your wine
cooler to the mains supply and switch on.

Care When Handling

Hold the wine cooler around its sides or base when moving it. Under no circumstances should it
be lifted by holding the edges of the top surface.

Installation

Don't cover or block the sides of your wine cooler.

Servicing

This wine cooler should be serviced by a qualified technician and only genuine spare parts
should be used. Under no circumstances should you attempt to repair the wine cooler yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunctioning.

Switching Off for Long Periods of Time

When the wine cooler is not in use for a long period of time, disconnect it from the mains
supply, empty all wine and clean the wine cooler, leaving the door ajar to prevent unpleasant
smells.

Disposal

Old units still have some residual value. An environmentally friendly method of disposal will
ensure that valuable raw materials can be recovered and used again. The refrigerant and
insulation materials used in the unit require special disposal procedures. Ensure that none of the
pipes on the back of the unit are damaged prior to disposal.
Up to date information concerning options of disposing of your old unit and packaging from
the new one can be obtained from your local council office.
If your unit is fitted with a lock, to prevent children being trapped inside, keep the key out of
reach and not in the vicinity of the unit.
When disposing of an old unit break off any old locks or latches and remove the door as a
safeguard.
14
LWC32B10_IB_final110309.indd 14
09/03/2011 11:43 AM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LWC32B10 and is the answer not in the manual?

Questions and answers

Table of Contents