Collapsing The Wakeboard Tower - Yamaha AR 210 Owner's/Operator's Manual

COLLAPSING THE WAKEBOARD
TOWER
The Wakeboard Tower can be col-
lapsed for boat storage in a building or
under a canopy or carport.
• Accidentally dropping the upper
tower section while collapsing or
raising it can damage the tower,
the boat, or both. An assistant
needs to help hold the upper
tower section in place during the
procedure.
• Do not operate the boat or trans-
port it on the trailer with the tower
in the collapsed position to avoid
possible damage.
Collapsing
1) Remove wakeboards and any other
accessories from the wakeboard
racks. Fold and secure the Bimini
top (if up).
2) Have the two short tower storage
supports ready. While an assistant
holds the upper tower section in
the middle, remove the inboard-side
knobs from the bottom end of the
tower supports on each side.
S
F
AFETY
EATURES
Rear Tower Support
Inboard Knob
Outer Knob
Upper Knob
3) Remove the knobs from the upper
end of the tower supports, and then
rotate the tower supports toward the
back of the boat so they rest against
the tower support bar. If desired,
the tower supports can be removed
completely and stored in one of the
boat's storage compartments.
4) Attach the short tower storage sup-
ports to the bottom mount on each
side and install the knobs, leaving
them slightly loose. Have the assis-
tant lower the upper tower section
until it is at the correct height for the
short tower storage supports.
5) Line up the short tower storage sup-
port with the hole in the upper tower
section on each side. Install the
knobs, but leave them slightly loose.
Once all supports and knobs are in
place, tighten all knobs securely.
2-21
I
& F
NFORMATION
UNCTIONS
#
2