Adjusting The Position Of The Armrest In Depth; Adjusting The Seat Angle - Invacare Fox User Manual

1. Loosen screw A.
2. Adjust armrest to required position.
3. Retighten the screw.
4. Repeat this procedure for the second armrest.
6.5 Adjusting the position of the armrest in
depth
WARNING!
Serious risk of injury if an armrest falls out of its
bracket because it was pulled too far forward.
– The armrest may be pulled forward out of the bracket
as far as the point where the end of the inserted tube
is flush with the rear of the bracket, but no further.
Requirements:
•
Allen key 3 mm
1577074-A
Adjusting the mobility device to the user's seating posture
1. Loosen the screws A and move the armrest in depth.
2. Tighten the screws securely.

6.6 Adjusting the seat angle

CAUTION!
Adjusting the seat tilt or the backrest angle
changes the geometry of the mobility device and
directly influences its dynamic stability!
– For details regarding dynamic stability, negotiating
gradients and obstacles and the correct adjustment
of seat tilt or backrest angle, refer to 5.3 Taking
Obstacles, page 22 and 5.4 Driving up and down
gradients, page 23.
Requirements:
•
10 mm open-ended spanner
•
5 mm Allen key
The possible seat angles are marked on a scale on the center post.
Depending on the rear seat height, you need to use the bottom or
top scale respectively:
•
Upper seat height: use the bottom scale
•
Lower seat height: use the top scale
27