Helpful Hints And Tips - Electrolux EWC 1350 User Manual

Hide thumbs Also See for EWC 1350:
Table of Contents

Advertisement

Available languages

Available languages

Before you make any change, you must
pause the washing machine by pressing the
button 6.
The programme can be changed as long as
the button 6 has not been pressed. Chang-
ing a running programme is possible only
by resetting it. Turn the programme selector
dial to "Aus/Arrêt" and then to the new
programme position. Start the new pro-
gramme by pressing the button 6 again.
INTERRUPTING A PROGRAMME
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing light starts to flash. Press the button
again to restart the programme.
CANCELLING A PROGRAMME
Turn the selector dial to "Aus/Arrêt" posi-
tion to cancel a programme which is run-
ning. Now you can select a new pro-
gramme.
OPENING THE DOOR AFTER THE
PROGRAMME HAS STARTED
First set the machine to pause by pressing
the button 6.
After some minutes, the door can be
opened, when the following conditions are
observed:
• The water temperature is below 55°C.
• The water level is below the bottom edge
of the door.
• The machine doesn't spin.
If you cannot open the door but it is abso-
lutely necessary to open it you have to

HELPFUL HINTS AND TIPS

SORTING OUT THE LAUNDRY
Follow the wash code symbols on each
garment label and the manufacturer's
washing instructions. Sort the laundry as
follows: whites, coloureds, synthetics, deli-
cates, woollens.
TEMPERATURES
for normally soiled white cot-
95° or 90°
tons and linen (e.g. tea cloths,
towels, tablecloths, sheets...)
switch the machine off by turning the selec-
tor dial to "Aus/Arrêt". After few minutes
the door can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to
set the programme and the options again
and then press the button 6.
AT THE END OF THE PROGRAMME
The machine stops automatically.
The pilot light " End" illuminates to indicate
that the programme has finished. The pilot
light "Door" goes out, the door can be
opened and the laundry can be removed.
If at the end of a programme there is water
in the tub (when the Rinse Hold option has
been selected), to empty out the water
follow the following instructions:
• turn the programme selector dial to
"Aus/Arrêt"
• select the «Drain» or «Spin» programme
• press the "Start" button
When the pilot light "Door" goes out, the
door can be opened and the laundry can
be removed.
At the end of the cycle, turn the programme
selector dial to "Aus/Arrêt" to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap.
Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
for normally soiled, colour fast
garments (e.g. shirts, night
dresses, pyjamas....) in linen,
60°/50°
cotton or synthetic fibres and
for lightly soiled white cotton
(e.g. underwear)
for delicate items (e.g. net cur-
tains), mixed laundry including
40°-30°-
synthetic fibres and woollens
Cold
bearing the label «pure new
wool, machine washable, non-
shrink»
electrolux 9

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents