Hunter 99111 Getting Started

Getting Started
OFF
Remove the canopy. If uncertain how
Before installing the Universal
to remove it, reference the fan's owner's
Remote Control Receiver,
manual. With wiring exposed, it may be
use the pull chains to set the
helpful to note existing wire connections
fan speed to HIGH and the
or take a digital photo for reference.
light to ON. Be sure power is
Remove the wire connectors that connect
OFF before proceeding with
the wires from the outlet box to the fan,
installation.
leaving the grounding wires connected.
Wiring the Receiver
CONNECT WIRES FROM
RECEIVER TO FAN -Using
the blue wire connectors
connect the white wire
from the receiver (marked
"common out") to the white
wire from fan. Connect the
black wire from the receiver
(marked "fan out") to the
black wire from the fan.
Connect the blue wire from
the receiver (marked "light
out") to the blue wire (or
possibly black with white
stripe) from the fan. Note:
The red wire from the
receiver has a pre-installed
wire terminator. It will not
be used.
If you are uncertain about
wire colors or connections,
please contact a qualified
electrician.
Turn the splices upward and push them carefully back through the hanger bracket
into the outlet box. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the outlet box.
Universal Ceiling Fan
Wall Control
Model #99111
Receiver
Canopy
Choose the hanging system that most closely resembles the one used by your fan and install the receiver and wire as directed.
Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8" remaining. Re-strip the fan lead wires 1/2" . Place remaining excess wire into
the ceiling electrical box. The bracket and fan must remain properly grounded.
You may have installation issues if the fan is installed on an angled ceiling.
Wiring the Wall Control
CONNECT WIRES FROM
RECEIVER TO WIRES FROM
OUTLET BOX - Using an
orange wire connector
connect the black wire
(ungrounded) from the
ceiling to the black wire from
the receiver (marked "live
in"). Connect the white wire
(grounded) from the ceiling
to the white wire from the
receiver (marked "neutral in").
AFTER ALL WIRES ARE
CONNECTED and secured
with wire connectors,
re-install the canopy.
After removing the switch plate
cover, remove all wiring from
M0033-01 • 09/17/12 • © Hunter Fan Company
Receiver
OR OR
Canopy
Using orange wire connectors,
connect the two black wires
the switch. (ungrounded) from the outlet
box. Also connect the two green
or bare wires (grounding) from
the outlet box with the grounding
wire from the wall control.
To avoid possible electrical shock, before installing or servicing your fan, disconnect the power by turning off
the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.
www.HunterFan.com
For low pro le fans, the receiver should
be secured to the hanger bracket with
a cable tie.
Ceiling
Cable Tie
Plate
OR
Receiver
Receiver
Canopy
Insert the wall control into Install the cover plate using a
the outlet box and secure the
Phillips Head screwdriver to
two screws using a Phillips secure the two cover plate screws.
head screwdriver.
1.888.830.1326
Ceiling
Bracket
Fan Body