Sony UP-895 Service Manual page 12

Printing
Making copies of the last printout
Press the COPY button. The printer makes a copy of the
last printout. The image of the last printout is retained in
the printer's memory until you press the PRINT button
again or turn the power off.
To copy in different directions and sizes
You can copy the last printout in different directions and
sizes except in SMALL mode.
Before pressing the COPY button, select the printing
direction and size as described in "Selecting the Printing
Direction/Image Size" (See this page.)
Notes
• If you press the COPY button immediately after
turning the power on, the alarm buzzer will sound as
nothing is stored in memory.
• In the SMALL mode, if you press the COPY button
after you have pressed the PRINT button only once, the
alarm buzzer will sound and the printer will not copy.
To make multiple copies of the same printout
Press the COPY button as many times as necessary
(maximum 11 copies including the first printout) while
printing or copying the first printout. Each time you press
the COPY button, a short buzzer sounds.
To interrupt copying
Press either the OPEN or FEED button.
28 Operation
Selecting the Printing Direction/
Image Size
You can make variations of printouts using the STD/
SIDE selector, image size selectors and the DIP
switches.
Selecting the printing direction
You can select the printing direction using the STD/
SIDE selector.
To print in the same direction as the one displayed in
the video monitor, set the selector to STD (standard).
To print the image in the direction where the image is
rotated by 90 degrees counterclockwise, set the
selector to SIDE.
STD SIDE STD SIDE
Image displayed on the video monitor
Printouts
When set to the STD When set to the SIDE
position position
Selecting the image size
You can print in normal or small size by changing the
image size selector.
You can also obtain a printout of the image at the left or
right, top or bottom of the video image on the monitor
after it has been enlarged twice.
Variations of printouts
Printouts obtained by the combination of the
STD/SIDE selector and image size selector
The table in the right colum shows various printouts that
can be obtained according to the combination of settings
of the STD/SIDE selector and image size selectors.
NOR
SML R/T 2×
STD SIDE
L/B
BOTH
In addition to variations in the right colum, the following
printout variation is available.
Negative printouts
You can make negative printouts by setting the POSI/
NEGA switch on the front panel to the NEGA position.
Printing
Image size Printing direction selector position
selector
position STD SIDE
NOR
(Normal)
SML
(Small)
R/T
(Right/Top)
L/B
(Left/Bottom)
BOTH
29
Operation